DDub Tech filament starting profiles, version 1
Not print-tested and not yet GUI-import tested. Review every setting before printing.
These are generic-material-based starting points, not printer-specific validated tunes.
Product temperatures, nozzle / bed: PLA Pro 220 / 40 C; PETG 255 / 70 C;
ABS 255 / 100 C; TPU Shoeflex 9075A 255 / 35 C. All 1.75 mm.
Apply listed temperatures to first and subsequent layers. Check hardware/plate limits.
Generic unsupported plate zero values stay disabled. TPU generic max temperature is
raised only to 255 C to include the product starting point, not a claimed temperature range.
Flow, density, fan, volumetric limit and retraction remain generic defaults where present.
They are not UniFilasTech measurements. TPU is softer than typical generic TPU defaults.
Run flow/temperature calibration and tune TPU speed and retraction before full prints.

IMPORT: Extract ZIPs first. Never import all-in-one ZIP as a slicer project.
Bambu Studio: File > Import > Import Configs. Parent: Generic PLA/PETG/ABS/TPU.
Compatibility remains the parent's X1/P1S family and listed nozzles, not A1 or every Bambu.
OrcaSlicer: File > Import > Preset Configs (called Import Configs in some versions).
Requires the installed Generic material @System presets from OrcaFilamentLibrary.
PrusaSlicer: File > Import > Import Config Bundle. Self-contained material-only INI.
Derived from Prusa's Generic PLA/PETG/ABS/FLEX material settings; printer G-code,
pressure advance, MMU loading and printer filters deliberately not copied.
Cura: Preferences > Configure Cura > Materials > Import (or Settings > Material > Manage
Materials > Import). Select a 1.75 mm printer. These are material profiles, not .curaprofile
quality profiles. Verify compatible quality and initial-layer temperatures after selecting.
Creality Print: File > Import > Import Configs. K1 0.4 mm only; generic K1 parents required.
Other printers: duplicate YOUR printer's generic material and apply the same product temps.

ABS: enclosure recommended and well-ventilated space, per product page.
TPU: slow printing, low retraction and direct drive recommended, per product page.
No fan percentage, numeric speed or numeric drying schedule supplied by product pages.
Slicer versions can change preset names and import UI. A missing parent needs the matching
built-in material installed. Do not remove compatibility filters to force a wrong printer.

Cura TPU internal quality family: TPU 95A. This is a generic compatibility category,
not product hardness. Display label is Shoeflex 9075A; actual listed input hardness is 90A.
